Descargar Imprimir esta página

Janome Sewist 625E Manual Del Usuario página 52

Publicidad

Janome 625E Sewing Machine Instruction Manual
q
w
r
t
y
w
e
www.janomeflyer.com
Button Sewing
e
Machine setting
q Stitch pattern: C
w Stitch width:
e Stitch length:
r Thread tension:A
t Presser foot:
y Feed dog:
Unthread the needle. Adjust the stitch width to match it
with the span of the holes in the button. Turn the
handwheel to check if the needle enters into each hole in
the button.
Lower the foot to hold the button in place.
The holes in the button should align with the slot of the
foot.
A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both holes
in the button.
q Pin
Re-thread the needle and sew about 10 stitches and cut
the needle and bobbin threads at the beginning.
q
Raise the presser foot and remove the fabric. Cut the
needle and bobbin threads leaving 8" (20 cm) tails.
Bring the needle thread between the button and fabric
through the holes in the button.
Pull the needle thread to pick bobbin thread up to the
right side of the fabric.
Wind the threads to from a shank and tie them together.
w Needle thread
e Bobbin thread
NOTE:
Raise the feed dog after sewing.
48
Adjust as necessary
Any
Buttonhole foot B
Lowered
625E Owners Manual/ User Guide

Publicidad

loading