Cleaning / Repairing The Unit - Xylem SI Analytics CT 72/P Manual De Instrucciones

11.

Cleaning / repairing the unit

Caution
Cleaning / repairing the unit
•
Always turn off the unit and disconnect the mains cable from the power source
before cleaning the unit.
•
Prevent humidity from entering into the circulator.
•
Electrical connections and any other work must be performed by qualified
personnel only.
•
Acryl-baths are not resistent to solvents.
Do not use detergents containing alcohol or solvents.
Cleaning:
For cleaning the bath tank and the immersed parts of the circulator, use low surface
tension water (e.g., soap suds).
Clean the outside of the unit using a wet cloth and low surface tension water.
The Thermostat is designed for continuous operation under normal conditions.
Periodic maintenance is not required.
The tank should be filled only with a bath fluid recommended by SI Analytics GmbH.
To avoid contamination, it is essential to change the bath fluid from time to time.
Repairs:
Before asking for a service technician or returning a circulator for repair, please
contact our service station.
SI Analytics GmbH
Hattenbergstrasse 10
D-55122 Mainz
Telefon +49 61 31 / 66 51 11
Telefax +49 61 31 / 66 50 01
E-Mail: si-analytics@xyleminc.com
www.si-analytics.com
When returning a unit, take care of careful and adequate packing. SI Analytics
GmbH is not responsible for damages that might occur from insufficient packing.
97