Mode Key; Direct Pattern Selection - Janome 3022 Manual De Instrucciones

r
(1)
(2)
(3)
t
r

Mode key

Each time you press this key the mode will change in
the following order:
(1) Pattern selection mode
The green light on the top will be on.
To select the pattern, press the
pattern number of the desired stitch is indicated (see
the stitch chart below).
(2) Stitch width adjusting mode
The green light in the middle will light up.
The stitch width of the selected pattern will be
indicated.
To alter the stitch width, press the
(3) Stitch length adjusting mode
The green light on the bottom will light up.
The stitch length of the selected pattern will be
indicated.
To alter the stitch length, press the
t

Direct pattern selection

4 commonly used stitches can be selected by
pressing the button under the pattern icon.
12
key until the
key.
key.