Char-Griller Duo 5050 Manuel Du Propriétaire página 58

Step 1:
with four 2 1/4" Hex Bolts, four Flat Washers, four Lock Washers, and four Hex Nuts. Orient the
Leg so that the holes on the Legs and Leg Cross Bar are pointing in the direction of the Leg
Braces Side, see Below. NOTE: The orientation of the Legs are critical for later steps so pay
careful attention to how they go together.
Hex Bolts
Short Leg
Step 2:
other set of Leg Cross Bar, Short Leg, Long Leg, and Wire Shelf using four 2 1/4" Hex Bolts,
four Flat Washers, four Lock Washers, and four Hex Nuts. First insert the Wire Shelf extend
bars at the end of the Wire Shelf into the upper hole on the Long Legs then insert a bolt
through the Leg Brace, Long Leg, Flat Washer, Lock Washer, and loosely tighten with a Hex Nut.
Then Place the other Leg Cross Bar, Short Leg in place (making sure that the holes on the Leg
Cross Bar and Short Leg are pointing in the direction of the Leg Brace) and secure them with
Hex Bolts and Hex Nuts. NOTE: The orientation of the legs are critical for later steps so pay
careful attention to how they go together.
Long Leg
B-4
Assemble the Leg Cross Bar, Short Leg, Long Leg, and Leg Braces then secure them
Hex Nuts
Leg Brace
Lock Washers
Lay down the assembly on the floor with the Leg Braces pointing up then install the
Flat Washer Lock Washer
Leg Cross Bar
Leg Cap
Flat Washers
Wire Shelf
Hex Nuts
Leg Brace
Hex Bolts
Long Leg
Short Leg
Hex Bolt
Leg Cross Bars