Descargar Imprimir esta página

Char-Griller Duo 5050 Manuel Du Propriétaire página 79

Ocultar thumbs Ver también para Duo 5050:

Publicidad

Idiomas disponibles

Idiomas disponibles

Ashes left in bottom of CHARCOAL GRILL for too long hold moisture and may cause rust if not
cleaned out.
GRILL is made of steel and cast iron, which WILL rust, especially without proper care.
Do not use self-starting charcoal, as it gives off an unnatural flavor. Burn lighter fluid off completely
before cooking.
After use, coat bare metal with vegetable oil to reduce rust. Remove EXTERIOR rust with wire brush
and touch up with high heat paint, available at most hardware/auto stores.
Make sure to empty GREASE TRAY after every use once completely cooled.
HEAT GAUGES maintain moisture, which will result in steam during cooking.
Fill unwanted holes with extra nuts and bolts (not provided). Note: Smoke will escape from other
areas than smokestacks. This will not affect cooking.
Grill must be installed on stable, flat surface.
It is recommended that CHARCOAL GRILL be heated up and fuel kept red hot for at least 30
minutes prior to first time cooking. Do not cook before briquettes have turned gray with ash.
WARNING! Accessible parts may be very hot. Use outdoors only.
WARNING! Do not use spirit or petrol when lighting or relighting.
WARNING! Keep children and pets away from appliance.
TROUBLESHOOTING
GAS GRILL TROUBLESHOOTING
Problem
Burner will not light using
knobs.
Burner will not light with
match.
Possible Cause
Wires and/or electrode
covered with cooking residue
Electrode and burners are wet Wipe dry with cloth
Electrode cracked or broken-
sparks at crack
Wire loose or disconnected
No gas flow
Coupling nut and regulator not
connected
Prevention/Cure
Clean wire and/or electrode
with rubbing alcohol
Replace electrode
Reconnect wire or replace
electrode/wire assembly
Check if propane tank is
empty. If propane tank is not
empty, refer to "Sudden drop
in gas flow or reduced flame
height." If empty, replace or
refill.
Turn the coupling nut about
one-half full connected to
three quarters additional turn
until solid stop. Tighten by
hand only. Do not use tools.
C-7

Publicidad

loading