Programming The Telephone - Fermax DUOX SKYLINE KIT 3-12L Manual De Instalador

DUO DUO X SKYLINE KIT 3-12L X SKYLINE KIT 3-12L
DUO DUOX SKYLINE KIT 3-12L DUO X SKYLINE KIT 3-12L X SKYLINE KIT 3-12L
DUO DUO DUOX SKYLINE KIT 3-12L X SKYLINE KIT 3-12L X SKYLINE KIT 3-12L X SKYLINE KIT 3-12L
DUO DUO X SKYLINE KIT 3-12L
QUICK PROGRAMMING GUIDE
1. CONFIGURE AS MASTER PANEL
The programming is always done from the MASTER panel and there can only be one in
the complete installation.
Configuring the master panel: Press the SW1 button 3 times quickly, it is activated as
a MASTER panel and a confirmation tone sounds (beep-beep).

2. PROGRAMMING THE TELEPHONE

1
1. With the telephone connected, press the programming button (you will hear a beep).
Upon releasing it, you will hear the entrance into programming.
2. Press the call-to-residence button. A programming confirmation is produced.
* The telephone will not function if it has not been programmed.
3. DEACTIVATE MASTER MODE ON THE PANEL
Once having completed the terminal´s configuration, deactivate the MASTER panel to
avoid accidentally reprogramming terminals.
Deactivating the master panel: Press the SW1 3 times consecutively fast, and it will
deactivate the panel as MASTER. A deactivation tone sounds (beep-bop).
4. ENCODING PANELS
Whenever there are more than one panel (to a block) you must program the panel
number, but for this you need key 7439.
6 way cable
Connecting the keypad:
a) With the power off, remove the skyline button module connected to the CN1 on the
amplifier.
b) Use the 6 way cable to connect the keypad as shown in the diagram.
c) Reconnect the power supply. Now you can program the required parameters with the
keypad.
d) Before completing the keypad disconnection operations and connecting the new
skyline button module, remove the power.
Pag 58
Programming button.
CN9
SW1
SW1 PROG
CN9 TAMPER
CN2
ENTRADA/INPUT
ARRIVÉE/EINTRITT
UP
SALIDA/OUTPUT
SORTIE/AUSGANG

< 2,5 min
DUOX AMPLIFICADOR
CN1
AMPLIFIER
A
AUDIO
B
C
CN1 SKYLINE MOD.
D
E
F
DL2
DL2 LED
IDIOMA
LANGUAGE
ONE
EXIT
TO
ONE BUS
18Vdc
- +
CN3 B B C NO NC +12 BS S GND
NC VERSION
:
C
NO
CN1
1
4
MÓDULO TECLADO
KEYPAD MODULE
MODULE CLAVIER
TASTATURMODUL
7
A
CN2
2
5
A
2 3
5 6
8 9
0 B
ENGLISH