Programming The Telephone - Fermax CITYLINE DUOX Serie Manual De Instalador Y Usuario

DUO DUO DUO DUOX CITYLINE KIT 1-2L DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUO DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUO DUO DUOX CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
If your installation is characterised by having General Inputs, Interior Blocks and/or
Sub-blocks, and must also program:
Position Adjustments Parameter Possible Values [default]
Panel type
03
04 Block no. (BK)
05
Sub-Block no. (BS)
We recommend filling in the amplifier's sticker once each panel is programmed.
EG 1
Examples:
MARCAR TIPO
EG BK SB
2. CONFIGURE AS MASTER PANEL
The programming is always done from the MASTER panel and there can only be one in
the complete installation.
Configuring the master panel: Press the SW1 button 3 times quickly, it is activated as
a MASTER panel and a confirmation tone sounds (beep-beep).

3. PROGRAMMING THE TELEPHONE

1
1. With the telephone connected, press the programming button (you will hear a beep).
Upon releasing it, you will hear the entrance into programming.
2. Press the call-to-residence button. A programming confirmation is produced.
* The telephone will not function until it has been programmed.
4. DEACTIVATE MASTER MODE ON THE PANEL
Once having completed the terminal's configuration, deactivate the MASTER panel to
avoid accidentally reprogramming terminals.
Deactivating the master panel: Press the SW1 3 times consecutively fast, and it will
deactivate the panel as MASTER. A deactivation tone sounds (beep-bop).
5. RESET TO DEFAULT VALUES (if necessary)
A 4444 (beep-beep) 13 (beep) 1 (beep-beep)
0:
Sub-Block (SB)
[1]:
Block (BK)
2:
General Entrance (EG)
00-99
[00]
00-99
[00]
NÚMERO
MARCAR TIPO
BK SB PL EG
1
Programming Button
BK 1
NÚMERO
BK SB PL
BK SB
1

< 2 min
Comments
Configuration of the panel
type
Block number the panel
belongs to
Sub-Block number the
panel belongs to
SB 1
MARCAR TIPO NÚMERO
EG BK SB PL
BK SB
1
2
A
5
Pag 25