Gram ZFOC Serie Manual De Utilización página 10

Backlight level: Press
countdown of power on —> press the
(0-7 level. the default backlight level of scale is level 3) press
this interface.
Backlight time: Press
countdown of power on —> input the backlight time —> press the
confirm —> press
Note:
Default backlight time is 2 seconds. User-defined 1-200 seconds at will. the
backlight will be on all the time if the time be set 200 seconds (display 'F' on
the Total Price Column): If the scale enters into the power saving status. the
backlight will be off. Backlight time should lower than sleep tune.
Scale protocol transferring
1. Power on your scale, then you can press
protocol transferring setting.
2. Press the
screen is to show signals BELOW.
CO,D0. Passive sending out.
C1,D1. Wagon balance scale active sending out.
C2,D2. FTP scale active sending out.
You can enter any section you need by pressing
10
key to enter the setting interface during the
key to enter the setting interface during the
key to exit this interface.
(model with RS-232)
key for switchover, at that time the left side of display
key to switch the backlight level
key to enter into scale
key and press
key to exit
key to
for exit.