Introduction - John Bean T1545 Manual Del Operador

12
- EN
T1545T

3.0 Introduction

Congratulations on purchasing the pneumatic-electric
tire changer: T 1545 John Bean
This tIre changer is designed for ease of operation, safe
handling of rims, reliability and speed.
With a minimum of maintenance and care your tIre
changer will provide many years of trouble-free operation.
Instructions on use, maintenance and operational
requirements of the machine are covered in this manual.
STORE THIS MANUAL IN A SAFE PLACE FOR ANY
FURTHER REFERENCE. READ THIS MANUAL
THOROUGHLY BEFORE USING THE MACHINE.
Application.
The tire changer is intended to be used as a device for
automatically demounting, mounting and beading car
and motorcycle tIres mounted on one-piece rims with the
following specifi cations:
Maximun tIre diam.:
Maximum tIre width:
This device must be used in the application for which it is
specifi cally designed.
Any other use shall be considered as improper and thus
not unreasonable.
The manufacturer shall not be considered liable
for possible damage caused by improper, wrong or
unreasonable use.
Manuals to the unit.
· Quick Start
EAZ0090G04A
· Spare Parts Manual
TEEWH581A3 - Service Manual
Manual for use by service personnel only.
· Operator's Manual
ZEEWH581A06 (Chapter 1 – 9)
The operator must be familiar with it.
· Accessory Plan (on Web).
Installation instructions.
The installation instruction are in Chapter 9 Appendices.
EC DECLARATION
(Original document contained in Spare Parts Booklet)
50" (mm 1270)
15" (380 mm)