GYS GYSFLASH 8.12 PL Manual De Instrucciones página 9

Operating manual
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging
the connections to/from the battery.
• Always ensure the Red clamp is connected to the «+»
battery terminal first. If it is necessary to connect the black
clamp to the vehicle chassis, make sure it is a safe distance
from the battery and the fuel/exhaust pipe. The charger
must be connected to the power supply.
• After charging, disconnect the charger from the mains,
then disconnect the negative clamp from the car body and
then disconnect the positive clamp from the battery, in this
order.
Power supply:
• Class II equipment
• This equipment complies with standard IEC 61000-3-12.
• This equipment complies with standard IEC 61000-3-11.
Maintenance:
• If the power cable is damaged, it must be replaced by the
manufacturer, its after-sales service, or an equally qualified
person to prevent possible danger.
• Maintenance should only be carried out by a qualified person.
• Warning!
Always disconnect from the mains before carrying out
maintenance on this machine.
• If the internal fuse has blown, it must be replaced by
the manufacturer, the service department or a similarly
qualified person in order to avoid a safety hazard.
• Do not use solvents or any agressive cleaning products.
• Clean the surfaces of the unit with a dry cloth.
Regulations:
• Equipment complies with European directives
• The Declaration of Conformity is available on our website.
• The Eurasian Economic Community (EAEC) mark of
conformity.
• This equipment conforms to UK requirements.
The UK Declaration of Conformity is available on our we-
bsite (see cover page).
• This device complies with Moroccan standards.
• The C‫( م‬CMIM) declaration of conformity is available on
our website.
Disposal:
• This machine is subject to selective collection. Do not
dispose of in domestic waste.
Translation of the original
instructions
GYSFLASH 8.12 PL
9