SFS GESIPA Birdie Manual Del Usuario página 29

Troubleshooting
Fault
Blind rivet not set
Rivet mandrel not removed
LED lights white – slow flashing
flashing
red – continuously lit
white – slow flashing
white – continuously lit
red – rapid flashing
white – rapid flashing
red – slow flashing
red – continuously lit
red – rapid flashing
white – rapid flashing
English
Cause
Battery empty
Jaws dirty or worn
Chuck mechanism loose
Blind rivet outside of
working range
Nosepiece is too small
Head sleeve dirty inside
Spent mandrel container
full
Mandrel channel
jammed
Blind rivet outside of
working range
Battery empty
Wrong battery
Blind rivet tool
overloaded – riveting
process aborted
Blind rivet tool blocked
on return stroke
Temperature warning –
device shutdown
imminent
Temperature stop –
device overheated/
too cold
Motor blocked
Remedy
Charge battery;
replace if necessary
Clean and oil or grease
sliding surfaces,
replace if necessary
Screw tight
Select blind rivet
according to technical
data
Replace in accordance
with table
Clean
Unscrew and empty
Remove jammed
mandrels and make sure
subsequent ones are
ejected cleanly
Select blind rivet
according to technical
data
Replace battery
Insert correct battery
Select rivet dimensions
according to working
range.
Unscrew head sleeve
and remove blockage
Pause work
Allow device to cool
down/warm up
Repair by GESIPA
®
Service
EN
29