Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8. Maintenance & troubleshooting
Maintenance
•
If you clean and maintain your appliance on a regular basis, the life of your appliance will extend and the possibility of problems will
decrease.
•
We recommend the service of your appliance to be sercived every twelve (12) months by a service agent to ensure continued efficient
operation.
•
This appliance must only be serviced by an authorized person.
•
Check your gas hose and connections regularly for any signs of leaks and every time the gas cylinder is re-filled or fitted to the appliance
with every use.
Troubleshooting
In the case of a spattering flame or jet blockage:
•
Clean your burner ports in case of an over spill.
•
We recommend to clean or replace the jets every six (6) months to ensure continued efficient operation of your appliance.
•
Should the appliance operate abnormally after storage and all checks have not isolated the problem, the venturi may be blocked. A
blocked venturi would be indicated by a weaker yellowish flame or no flame at all in extreme cases. Under these circumstances it will be
necessary to remove and check and thoroughly clean out any foreign matter which may have gathered in the appliance.
•
This may be done by removing the jet using standard tools and blow any dirt from the jet, alternatively, you may purchase new jets from
your local store. Do not attempt to clean the jet mechanically.
Replacing a blocked jet:
•
Your Citi Chef 50 is fitted with a specific size jet to regulate the correct amount of gas.
•
Should the hole in the jet become blocked, this may result in a small flame or no flame at all. Do not attempt to clean the jet with a pin or
other such device as this may damage the orifice, which could make the appliance unsafe.
• To replace the jet: Pull the back panel out using the handle (Fig 7) Remove the dome, BBQ grid, pot stand and any other loose items from
the appliance. Now unscrew the 3 screws from underneath the appliance as shown in Fig 8, this will loosen the burner. Now remove the
burner gently by lifting it out (Fig 9), NOTE that it is attached to the piezo ignition wire. DO NOT yank the burner out otherwise you risk
snapping the piezo ignition wire from your appliance. Gently lay the burner to the side, this will reveal the jet (Fig 10). The jet can now be
removed using a suitable spanner. Do not use pliers on the jet as this may damage the jet, making it unusable or impossible to remove.
Screw the new jet into the valve. Do not over tighten as this may damage the jet.
• Reverse the above procedure to re-assemble the unit.
Replacing the Hose:
•
The fitting of a hose is described in Section 2.
Fig. 7
Fig. 9
8 8
Fig. 8
Jet
Fig. 10
Publicidad
