Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Lighting the appliance using the piezo
• To light up the appliance using the piezo igniter, push and turn the control knob in an
anticlockwise direction until you hear a click. If the gas does not ignite on the first spark,
turn the control knob back to its "OFF" position. Try again, by pushing and turning the
control knob anti-clockwise until you hear a click. If the gas has not ignited in the first two
to three seconds you should close the control valve by turing
the control knob back to its "OFF" position.
• Wait approximately thirty seconds to let any accumulated gas within the burner escape.
Repeat the above process if necessary until the flame ignites. The flame should normally
light up within the first one to two seconds.
Lighting up using a BBQ lighter
•
When starting cold, the appliance may be lit from the top prior to fitting the desired
cooking surface onto the fat pan. When lighting up a hot appliance, it is recommended
that this be done by sticking a barbecue lighter through one of the vent holes underneath
the burner, until it is in line with the burner (DO NOT place the BBQ lighter through the
large hole directly underneath the burner). Ignite the BBQ lighter. Whilst the BBQ lighter
is lit, push and turn the control knob anti-clockwise to light the burner.
General
•
Use the control knob to adjust the flame intensity to the desired level by turning the knob
clockwise to decrease the flame and anti-clockwise to increase the flame.
•
When cooking food with a high fat content, flaring may occur if the selected heat setting is
too high. Should this happen, turn the heat down until the flaring ceases.
•
The flame may be observed through the inspection hole provided for this purpose on the
side of the fat pan.
•
Do not move the appliance when in use. It is unsafe practice to move the appliance whilst
lit and may cause flaring.
•
After use, first close the control valve on the gas cylinder (if applicable). When the flame has
gone out, close the control valve on the device.
•
The fully closed position is at the furthest clockwise position. To rotate the valve from the
fully closed position it is necessary to first depress the knob just enough to move out of the lock mechanism. While holding the knob in, turn it
in an anti-clockwise direction.
Once the spindle has moved out of the lock position it is no longer necessary to keep the control knob depressed and it can be rotated
freely to the desired flame setting.
•
When not in use remove the gas cartridge
NOTE! If the appliance is used in windy conditions, the dome must be used as a wind shield, and placed in position (as shown in fig. 5).
Flame visibility check
•
It is important to check that the flame is still burning once you have lit your appliance.
•
To check for flame visibility, there is a visual slot on the BBQ grid. Flame visibility can also be viewed through the grid slots. (Fig 6)
•
For easy visibility, place the visual slot at the front (as shown).
Visual Slot
4 4
WIND
Fig . 5
Fig . 6
Publicidad
