Invacare Aquatec Pure Bidet Manual Del Usuario página 6

Aquatec® Pure Bidet
1. Open the shut off valve A completely by turning
counterclockwise.
2. Check for any water leakage on the connection hoses,
tighten if necessary.
Connecting the Power Plug
1. Read and follow the safety information regarding
electrical safety, → 2.1 General Safety Information, page
2 .
2. Connect power plug to a suitable power source.
3. If the power indication light is not turned on after the
power plug connection, press any button except HI/LO,
FR/BK buttons of the remote control, then power goes
on.
Checking the Key Functions
B
C
1. Place one hand on the seat sensor A.
2. With the other hand press "CLEANSING / STOP" on the
unit control panel B or "CLEANSING" or "BIDET" on the
remote control.
• Water sprays out of the nozzle. Cover the nozzle
with your free hand C to prevent water spattering
out.
4.4 Disassembly
Follow the below instructions if in need of detaching the
unit for removal.
1. Disconnect the power plug.
2. Close the water supply by turning the shut off valve
clockwise.
3. Drain the toilet water tank completely by flushing.
4. Disconnect the PVC flexible hose from the T-valve.
5.
Lift the device slightly and pull it forwards out of the
holder.
6
A
6.
Unfasten the drain plug A underneath the unit and drain
the water completely out of the water tank.
7. Disconnect the PVC flexible hose and T-valve.
8. Connect the water-supply hose from the water tank to
the shut off valve.
9. Open the shut off valve by turning counterclockwise.
10. Check the connections for any leakages, tighten if
necessary.
5 Usage
5.1 Safety Information
CAUTION!
Risk of Injury or Damage to Property
– Before every use, check the product for damage
and ensure that it is securely assembled.
– Do not use if defective.
5.2 Functional description of the self-cleaning
mechanism
The self-cleaning mechanism of the showering and cleansing
nozzle is automatically activated before and after each
function / use.
The showering and cleansing nozzle is automatically retracted
and rinsed with fresh water for approx. 5 seconds. Since
the shower and cleansing nozzle is at this time within the
device, water cannot be splashed when the lid is open.
When pressing a function key, the nozzle moves out again
and is ready for use.
When the device has been in standby-mode or has
been re-connected to the power supply, the self-cleaning
mechanism is activated once.
A
1590625-G