Invacare Aquatec Pure Bidet Manual Del Usuario página 7

5.3 Using Remote Control and Control Panel
C
B
Overview of key functions on remote control
Pos. Key name
A WATER / DRY
STOP (red button)
B
C CLEANSING/MOVE
D BIDET/MOVE
DRY
E
AUTO
F
SEAT
G
WATER
H
I FRONT / BACK
J HIGH / LOW
HIP BATH
T
HIGH / LOW
S
BATTERY SIGN
U
Overview of key functions on control panel
Pos. Key name
K CLEANSING/STOP
POWER SAVING
L
LIGHT
M
1590625-G
D
I I E
S A S
Function
Display of the current water
pressure or the temperature
of the warm air dryer
Red Button: Stops all active
functions
Cleansing function is
performed
Bidet function is performed
Warm air dryer function
begins to operate
Automatic cleaning function
starts
Adjusting seat temperature
Adjusting water temperature
Change nozzle position
Adjusting warm air dryer
temperature
Adjusting water pressure
Hip bath cleansing is
performed
Display of current water
temperature or seat
temperature
Illuminates when batteries
need to be replaced
Function
Device turns off
Power-saving mode activates
Night-light activates
Overview of key functions on control panel
Pos. Key name
LIGHT SENSOR
N
LED lights indicate the mode of the device:
POWER
O
LIGHT
P
AUTO
Q
SUPER
R
5.4 Using the Shower Toilet
Perform Manual Cleansing
A sensor is located inside the toilet seat, that is only
activated by skin contact.
1. If plugged-in, the device is turned on and the "POWER"
LED O illuminates on the control panel.
• If the "POWER" LED does not illuminate, press any
button on the remote control (except HIGH/LOW
or FRONT/BACK buttons).
2. Set yourself centered on the toilet seat.
3. Press the CLEANSING/MOVE button C or BIDET/MOVE
button D.
• CLEANSING respectively BIDET-function is performed.
4. Press again CLEANSING/MOVE button or BIDET/MOVE
button during the cleansing process.
• The cleansing nozzle moves back and forth. Nozzle
stops by pressing the button again.
5. Press STOP button B on the remote control.
• Shower procedure stops.
6. Press DRY button E on the remote control.
• Warm air dryer is activated. Dryer function stops by
pressing the "STOP" button.
7. Press CLEANSING/STOP button K and hold for more
than 4 seconds.
• The device is turned off — All displays switch off on
the control panel.
CLEANSING/MOVE and BIDET/MOVE function operates
for 90 seconds. Hip bath function operates for 3
minutes. DRY function operates for 3 minutes. The
functions are ending with an audible beep. Before
and after each operation, the self nozzle cleaning
function runs and sanitizes the nozzle head.
Perform Automatic Cleansing
The automatic cleansing function is a default function in
which a complete cleansing cycle is automatically executed.
Function
When night-light function is
activated, bidet automatically
senses toilet light and
night-light LED switches on
Unit switched on
Night-light activated
Automatic power-saving mode
activated
Super power-saving mode
activated
7