Publicidad
Idiomas disponibles
Idiomas disponibles
ADDITIVES SHOULD NOT BE USED TO
TRY TO ENHANCE THE POWER OR
PERFORMANCE OF MACHINE.
Note:
Do not mix gasoline and oil in the
product fuel tank. Oil that is at room
temperature mixes easier and more
thoroughly than cold oil.
50:1 Gas/Oil Mixing Chart
Recycling Tips
General Tips
Follow these instructions whether cutting grass or
leaves for the best cutting results and lawn
appearance:
Maintain a sharp blade throughout the cutting
season. Periodically file down nicks on blade.
Only mow dry grass or leaves. Wet grass and
leaves tend to clump on yard and may cause
mower to plug or engine to stall. They also may
be slippery to walk on and could cause you to
slip and fall.
POTENTIAL HAZARD
Wet grass or leaves can cause you to slip
and contact blade.
WHAT CAN HAPPEN
Blade contact can seriously injure you.
HOW TO AVOID THE HAZARD
Mow only in dry conditions.
EN–7
All manuals and user guides at all-guides.com
Cutting Grass
If the finished cut lawn appearance is unsatisfactory,
try one or more of the following:
Set engine speed to fastest position. Maximum
horsepower provides best cutting results.
Clean clippings or leaves from underside of
mower deck after each mowing.
Keep engine in good running condition. Cutting
and recutting requires more horsepower.
Clean air filter more frequently. Cutting and
recutting stirs up more clippings and dust which
clogs the air filter and reduces engine
performance.
Grass grows at different rates at different times
of the year. In the heat of the summer, it is
generally best to cut grass at the 1- / ", 2- / " or
2- / " height-of-cut settings (Fig. 10). Only
about 1/3 of the grass blade should be cut off.
Cutting below the 1- / " setting is not
recommended unless grass is sparse or it is late
fall when grass growth begins to slow down.
When cutting grass over six inches tall, you may
want to first mow using the highest height-of-cut
setting and a slower walking speed; then mow
again at a lower setting for best lawn appearance.
If grass is too long and leaves clumps on top of
lawn, mower may plug and cause engine to stall.
Alternate mowing direction. This helps disperse
clippings over lawn for even fertilization.
Sharpen the blade.
Walk at a slower pace while mowing.
Raise the height-of-cut setting on your mower.
Cut grass more frequently.
Overlap cutting swaths instead of cutting a full
swath with each pass.
Mow across the marginal areas a second time.
Set height-of-cut on front wheels one notch
lower than rear wheels. (example: set front
wheels at 1- / " setting and rear wheels at 2- / "
setting)
Publicidad
