Publicidad
Idiomas disponibles
Idiomas disponibles
Remove the cord or plug from the power and
then connect it again after 30 seconds or so. If
this does not cause the pilot lamp to blink in red
(every second), please take the charger to the
metabo HPT Authorized Service Center.
PRIOR TO OPERATION
1. Preparing and checking the work environment
Make sure that the work site meets all the conditions
laid forth in the precautions.
2. Checking the battery
Make sure that the battery is installed fi rmly. If it is at
all loose it could come off and cause an accident.
3. Power switch
Ensure that the power switch is in the OFF position.
If the battery is installed while the power switch is in
the ON position, the power tool will start operating
immediately, which could cause a serious accident.
4. Checking the Accessory
○ Check to see if the application tool is a genuine
component recommended by the manufacturer and
that there are no cracks or other damage.
○ Check to see if the application tool is properly installed
as instructed.
5. Changing application tools (Fig. 6)
CAUTION
● Be sure to switch power OFF and disconnect the
battery from the body when changing application
tools.
● Never touch the application tool immediately
after use. The metal is hot and can easily burn
your skin.
● The lever is attached to a strong spring. Be very
careful not to get your fi ngers caught when
pushing the lever down.
NOTE
○ Make sure the facing of the application tool is correct.
○ Make sure the application tool is properly set on the
protrusion of the attachment ring.
(1) Pull the lever up. There will be some resistance, but
make sure the lever is pulled until it is parallel with the
main unit.
(2) Pull and turn the guide sleeve until " " is aligned with
the " " mark.
(3) Pull out the tool shaft.
(4) Attach the application tool to the attachment ring,
making sure the tool's hole is fi tted to the ring's
protrusion. The angle of attachment for the application
tool can be set in 30° increments.
(5) Insert the tool shaft.
(6) Align the guide sleeve's " " mark to the " " position.
(7) Push down the lever.
(8) Align the holes when sticking the sanding paper to the
sanding pad.
English
13
Publicidad
