Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2.4.2. End limit readjustment
Attention
Control point must be paired to the motorised product.
͉
͉
Orange LED blinks slowly until the new end limit is recorded.
2.4.2.1. Readjusting the upper end limit
1) Briefly press the UP button, to move the motorised product
to the upper end limit.
2) Press and hold the UP and DOWN buttons simultaneously
until the motorised product briefly moves Up and Down.
3) Press and hold the UP or DOWN button to move the
motorised product to the new desired position.
4) To confirm the new position press and hold the MY button
until the motorised product briefly moves Up and Down and
green LED blinks 5 times.
2.4.2.2. Readjusting the lower end limit
1) Briefly press the DOWN button to move the motorised
product to the lower end limit.
2) Press and hold the UP and DOWN buttons simultaneously
until the motorised product briefly moves Up and Down.
3) Press and hold the UP or DOWN button to move the motorised
product to the new desired position.
4) To confirm the new position press and hold the MY button
until the motorised product moves Up and Down and green
LED blinks 5 times.
2.4.3. Modifying the drive rotation direction
1) Using the UP or DOWN button on the control point, move
the motorised product away from the end limits.
2) Press and hold the UP and DOWN buttons simultaneously
until the motorised product briefly moves Up and Down and
orange LED starts to blink slowly.
3) Press the MY button until the motorised product briefly
moves Up and Down to reverse the rotation direction and
green LED blinks 5 times.
4) Press the UP button to check the new rotation direction. The
drive rotation direction is reversed
2.4.4. Modifying the wheel rotation direction
1) Using the UP or DOWN button on the control point, move
the motorised product away from the end limits.
2) Press and hold the UP and DOWN buttons simultaneously
until the motorised product briefly moves Up and Down and
orange LED starts to blink slowly.
3) Press the UP, MY and DOWN buttons simultaneously, until
the motorised product briefly moves Up and Down, wheel
rotation is reversed and green LED blinks 5 times.
2.4.5. Erasing control points from memory
To delete all the programmed control points, press and hold
the drive head programming button until the motorised prod-
uct briefly moves Up and Down twice. All programmed control
points are deleted and green LED blinks 5 times.
6
Copyright
©
2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Sonesse 40 WireFree RTS Li-ion
1
2
3
4
1
2
3
4
1
3
1
2
3
2
4
2x
Publicidad
