Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ChefTop
Chamber temperature setting
The temperature inside the chamber is shown on the dis-
play panel 2 and is set with the
During the blast chilling / shock freezing cycle, if the core
temperature has been set, the display panel 2 shows,
alternatively, the set temperature and the temperature
taken by the core probe (flashing display panel).
-40°C
Delta T setting
Delta T value is shown on the display panel 2 and is set
with the
-40°C
Blast chilling / shock freezing start /
stop
To start a blast chilling / shock freezing cycle touch the
button
When the chilling starts, the led "START STOP" turns on.
To stop the blast chilling / shock freezing cycle touch the
button.
ENGLISH
5
™
buttons
+10°C
buttons
0°C
When the blast chilling / shock freezing cycle has finished,
both in manual and program mode, the blast chiller makes
an audible alarm for 15 seconds and the display 1 flashes
for 45 seconds. During this 45 seconds time the "START
/ STOP" led remains on:
•
if you touch the
led turns off and all settings are reset.
•
if none of the buttons are touched, after 45 seconds
have passed, "START / STOP" led turns off and all
settings are reset
WORKING WITH PROGRAMS
3.6
P00
P02
P10
The electronic control board allows the user to set, and
select, up to 70 blast chilling / shock freezing programs.
Program setting - by the user:
To set a program proceed as follows:
•
enter program mode by touching the
•
select the required number of the program to be set
by touching the
•
select the required settings (time, core temperature,
chamber temperature, Delta T); as for manual work-
ing, every blast chilling / shock freezing program can
be composed by 1 to 4 steps
•
to save the program press and hold the
for 5 seconds (after 5 seconds have passed you will
hear a bleep) the program is now saved.
ENGLISH
button the "START / STOP"
P01
button
buttons
button
Publicidad
Tabla de contenido
