Unox ChefTop XK304 Manual De Instrucciones página 9

8. MALFUNCTIONS – PROBLEMS CAUSES AND REMEDIES
BREAKDOWN
The blast chiller is completely
The blast chiller does not start
even though you have set the time
or the core temperature and
pressed START / STOP button
There is water coming out
through the door and the seal
even though the door is closed
9. BLAST CHILLER ERROR MESSAGES
BREAKDOWN
The display panel 1 shows the
message EA1
The display panel 1 shows the
message EA2
The display panel 1 shows the
message EA3
When you select ,and start,a blast
chilling / shock freezing program,
on the ChefTop control panel
the display panel 1 shows the
message EA4
The mains supply voltage is
Intervention of one of the fuses on
turned off
The electrical connection to the
mains has not been made in the
The door of the blast chiller is
open or not properly closed
Damaged door magnetic micro
Damaged door closing system
The connection wires of the
chamber probe are disconnected
Damaged chamber probe
Damaged blast chiller power card
The connection wires of the core
probe are disconnected from the
Damaged blast chiller power card
Overpressure in the refrigeration
Damaged blast chiller power card
CAUSE
missing
the power board
correct way
switch
Damaged door seal
CAUSE
from the power card
power card
Damaged core probe
circuit
Dirty filter
UNO X
SOLUTION
Restore the voltage
Apply to a qualified UNOX
technician for service
Check the connection of the
appliance to the mains
Close the door in the correct way
Apply to a UNOX qualified
technician for service
Apply to a UNOX qualified
technician for service
Apply to a UNOX qualified
technician for service
SOLUTION
Apply to a UNOX qualified
technician for service
Apply to a UNOX qualified
technician for service
Apply to a UNOX qualified
technician for service
Apply to a UNOX qualified
technician for service
Apply to a Unox qualified
technician for service
Apply to a UNOX qualified
technician for service
Disconnect the blast chiller from
the power supply, wait for about
20 minutes and re-connect the
appliance: if the display shows the
message EA3 again
apply to a UNOX qualified
technician for service
Apply to a Unox qualified
technician for service
Wash the filter and reset the
respective error message
ENGLISH
R
8