pellenc EXCELION ALPHA Manual De Instrucciones página 73

3. Turn the cutting head until you find the notch to block
the rotation of the cutting head support (8).
4. Insert the supplied Torx 25 spanner or the head of
a Torx 25 screwdriver into the notch of the cutting
head support (25).
5. Unscrew the cutting head clockwise on the motor
shaft.
6. Remove the screwdriver.
Note
If the cutting head is too tight:
1. Remove the cutting head cover (24).
2. Remove the reel (23).
3. Insert a tool through the eyelets of the cutting
head (8).
4. Use the tool to provide leverage to unscrew the
cutting head.
6.4.2. MOUNTING THE ALPHA CUT CUTTING HEAD
1. Check that the cutting head support (25) is on the
motor.
2. Position the cutting head (8) on the motor shaft.
3. Screw the cutting head counter-clockwise onto the
motor shaft.
GRASS STRIMMER EXCELION ALPHA
53_144013_C
73