Ohyama WOOZOO IPE-1221G Manual Del Usuario página 10

Introduction for buttons on
remote control
NOTE
● This is a general use remote control. It could be
used for the air conditioner with multifunction.
For the functions which the model doesn't have,
if press the corresponding button on the remote
control, the unit will keep the original running
status.
● When power is connected (stand by condition),
you can operate the air conditioner through the
remote control.
● When unit is on, each time you press the button
on remote control, the sending signal icon "
on the display of remote control will blink once. If
the air conditioner gives out a beep sound, it
means the signal has been sent.
● When unit is off, set termperature will be
displayed on the remote control (lf the light of
indoor unit display is turned on, the correspond-
ing icon will bedisplayed); When unit is on, it will
display the icon of the on-going function.
button
Press this button to turn unit ON/OFF.
button
MODE
Pressing this button once can select your required
mode circularly as below (the corresponding icon"
will be lit up after the mode is selected):
COOL
( IPE-1221GH Model only )
● Auto：when selecting auto mode, air conditioner
will operate automatically according to ambient
temperature. Set temperature can't be adjusted
and won't be displayed either. Press Fan button
to adjust fan speed.
● Cool：when selecting cool mode, air conditioner
will operate under cool mode. Then press" + "or"
-" button to adjust set temperature. Press Fan
button to adjust fan speed.
● Dry: when selecting dry mode, air conditioner will
operate at low fan speed under dry mode. In dry
mode, fan speed can't be adjusted.
● Fan: when selecting fan mode, air conditioner will
operate in fan mode only. Then press Fan button
to adjust fan speed.
● Heat (IPE-1221GH Model only ) : when
selecting heat mode, air conditioner will operate
under heat mode. Then press "+" or "- " button
to adjust set temperature. Press Fan button to
adjust fan speed. (Cooling only unit can't
receive heating mode signal. lf set heat mode
by remote control, press ON/OFF button can't
turn on the air conditioner.)
● Pressing "+"or "-" button once will increase or
decrease set temperature by 1°F(°C). Hold "+"
"
or "-" button for 2s, set temperature on rermote
controller will change quickly. Release the
button after your required set temperature is
reached. (Temperature can't be adjusted under
auto mode)
● When setting Timer On or Timer Off, press "+"
or "-" button to adjust the time. (See TIMER
Button for setting details)
Pressing this button can select fan speed
circularly as: AUTO, SPEED 1( ), SPEED 2(
SPEED 3(
NOTE
"
● Under Auto speed, air conditioner will select
proper fan speed automatically according to
DRY ambient temperature.
● Fan speed can't be adjusted under dry mode.
SWING
Press this button to turn on up & down air swing.
Under Cool, Heat and Dry mode, press this button
to turn on Sleep function. Press this button to
cancel Sleep function. Under Fan and Auto mode,
this function is unavailable.
TIMER
● When unit is on, press this button to set Timer
Off. T-OFF and H icon will be blinking. Within 5s,
6
button
button
), SPEED 4 ( ).
EN
pre
Off
de
for
bu
Th
Hic
● Wh
T-O
"+"
Pre
de
for
bu
Th
Hic
● Ca
pre
tim
can
NO
● R
● T
),
C
Pre
or t
fun
con
rem
T
Und
but
L
Und
"+"
to s
bei