Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and disassembly of
heat discharge pipe
Install heat discharge pipe
1.
Rotate joint A and Rear clip clockwise into
the two ends of heat discharge pipe.
Joint A
heat discharge pipe
2.
Insert joint A of heat discharge pipe into the gr-
oove until you hear a sound.
joint A
3.
Lead the heat discharge pipe outdoors.
clockwise
Rear clip
Groove
14
Note of Installing heat discharge
pipe
In order to improve cooling efficiency, the heat
discharge pipe should be as short as possible and
flat without curve to ensure smooth heat discharge.
The discharge pipe is suggested to be installed accord-
ing to below figure by the manufacturer.
User can adjust the installation method of the
discharge pipe basing on the requirement, while
the similar installation methods as below which will
lead to unsmoothly air-out are not allowed.
The length of the heat discharge pipe is less than
40 inches. It is recommended to use it with shortest
length.
When installing, heat discharge pipe should be as
flat as possible. Don't prolong the pipe or connect it
with other heat discharge pipe.
EN
Disa
b
1.
Re
Pre
2. Re
Publicidad
