Publicidad
Idiomas disponibles
Idiomas disponibles
Install Power cord Hooks
Assemble the power cord hooks at the back of the
●
unit with screws (the direction of power cord hooks
is as shown in following fig).
direction of power cord
hooks is upward
power cord hooks
screws
direction of power cord hooks is downland
Wind the power cord around the power cord hooks.
●
Drain Water
● To reach the maximum performance, it is not
recommended to drain water, during Cool mode.
● lt is recommended to use the middle drainage port to
drain water, during Dry mode.
● It is recommended to use the bottom drainage port
to drain water, during Heat mode.
● To drain water from the bottom drainage port when
the display shows "H8".
Drainage method
1
Drain water from the bottom drainage port.
Turn off the unit and pull out the plug from the socket.
●
Place a water container under the bottom drainage
●
port, or move the machine to a place where it can
drain.
Remove the rubber plug of the bottom drainage
●
port to drain water.
After draining, insert the rubber plug.
●
Press ON/OFF button to restart.
●
Bottom drainage port
2
Drain water from the middle drainage port.
NOTE
● Water can be automatically emptied into a floor drain by
attaching 14mm inner diameter hose (not included).
1.Remove the continuous drain cap 1 by turning it
counter clockwise then remove the rubber stopper
2 from the spout.
12
EN
Dra
2.
Sc
pa
3.
Ins
ATT
Whe
hole,
gard
down
impr
the c
in the
catio
Publicidad
