Publicidad
Idiomas disponibles
Idiomas disponibles
EN
press "+" or "-" button to adjust the time for Timer
Off. Pressing "+" or "-" button once will increase or
decrease the time by 0.5h. Hold "+" or "-" button
erate
for 2s, time will change quickly. Release the
on
button after your required set time is reached.
to
Then press TIMER button to confirm it. T-OFF and
Hicon will stop blinking.
de
● When unit is off, press this button to set Timer On.
n't
T-ON and H icon will be blinking. Within 5s, press
"+" or "-" button to adjust the time for Timer On.
Pressing "+" or "-" button once will increase or
decrease the time by 0.5h. Hold "+" or "-" button
or
for 2s, time will change quickly. Release the
"+"
button after your required set time is reached.
mote
Then press TIMER button to confirm it.T-ON and
Hicon will stop blinking.
s
● Cancel Timer On/off: If Timer function is set up,
nder
press TIMER button once to review the remaining
time. Within 5s, press TIMER button again to
"+"
cancel this function.
NOTE
● Range of time setting is: 0.5~24h.
● The interval between two motions can't exceed 5s,
otherwise the remote control will exit setting status.
),
Function introduction for
combination buttons
Child lock function
Press "+" and "-" buttons simultaneously can turn on
or turn off child lock function. When child lock
ct
function is started up, child lock indicator on remote
o
control is ON. lf you operate the remote control,
remote control won't send signal.
de.
Temperature display switchover function
Under OFF status, press "-" button and "MODE"
button simultaneously can switch between °C and °F.
ng.
Light function
Under switch-on or switch-off state, you may hold
"+" and "FAN" buttons simultaneously for 3 seconds
utton
to set the lamp on or off and send the code. After
being energized the lamp is defaulted on.
mode,
mer
in 5s,
Replacement of batteries in
remote control
Cover of battery box
1. Press the back side of remote control on the
spot marked with "
cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries and
make sure the positions of "+" and "-" polar are
correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal
sender at the receiving window on indoor unit.
● The distance between signal sender and receiving
window should be no more than 8m, and there should
be no obstacles between them.
● Signal may be interfered easily in the room where
there is fluorescent lamp or wireless telephone;
remote control should be close to indoor unit during
operation.
● Replace new batteries of the same model when
replacement is required.
● When you don't use remote control for a long time,
please take out the batteries.
● lf the display on remote control is fuzzy or there's no
display, please replace batteries.
7
EN
battery
reinstall
remove
", and then push out the
Publicidad
