Publicidad
Idiomas disponibles
Idiomas disponibles
Clean and Maintenance
WARNING
● Before cleaning the air conditioner, please turn
off the unit and disconnect power. Otherwise, it
may cause electric shock.
● Do not wash air conditioner with water.
Otherwise, it may cause electric shock.
● Do not use volatile liquid (such as thinner or
gas) to clean the air conditioner. Otherwise, it
may damage the appearance of air conditioner.
● Do not use liquid or corrosive detergent clean
the appliance and do not splash water or other
liquid onto it, otherwise, it may damage the
plastic components, even cause electric shock.
Clean outer case and grille
Clean outer case:
lf there's dust on the surface of
outer case, please use soft towel to
wipe it. lf the outer case is very dirty
(such as grease), please use
neutral abluent to wipe it.
Clean grille:
Use cleaner or soft brush to clean it.
Clean filter
1.Remove the filter
Press the clasp as shown in the fig, and then
remove the filter ;
2.Clean filter
Use cleaner or water to clean the filter. If the
filter is very dirty (such as grease), use warm
water 40°C (104°F) melted with neutral abluent
to clean it and then put at shady place to dry it.
3.Install filter
After the filer is cleaned and dried, reinstall it
well.
NOTICE
● The filter should be cleaned about once every three
months. If there's much dust in the operation
environment, you can increase clean frequency.
● Do not dry the filter with fire or hair drier. Otherwise, it
may be deformed or catch fire.
Clean heat discharge pipe
Remove the heat discharge pipe from air condition-
er, clean and dry it , and then reinstall it. (For the
method of installation and removal , please refer to
the instruction for "Installation and disassembly of
heat discharge pipe").
Checking before use-season
1. Check whether air inlets and air outlets are blocked.
2. Check whether plug and socket are in good
condition.
3. Check whether filter is clean.
4. Check whether batteries are installed in remote
controller.
5. Check whether joint, window bracket and heat
discharge pipe are installed tightly.
6. Check whether heat discharge pipe is damaged.
Checking after use-season
1. Disconnect power supply.
2. Clean filter and outer case.
3. Remove dust and sundries on the air conditioner.
4. Eliminate accumulated water in chassis (refer to the
section of "Drainage way" for details).
5.Check whether window bracket is damaged or not. lf
yes, please contact dealer.
Long-time storage
lf you don't use the air conditioner for a long time,
please maintain it by following steps for good
performance:
Make sure there's no accumulated water in chassis
●
and the heat discharge pipe is disassembled.
Pull out the plug and wrap the power cord.
●
Clean the air conditioner and pack it well to prevent
●
dust.
Notice for recovery
Many packing materials are recyclable materials.
●
Please deal with them through local recycle bin.
lf you want to throw away the air conditioner, please
●
contact local division or consultant service center for
the correct disposal method.
8
EN
Mal
Pleas
lf the
local d
Phen
Air
cond
can't
opera
Poor
coolin
(heat
Air
condi
can't
receiv
signa
remo
contr
remo
contr
not
sensi
You c
heard
soun
"PAP
There
abno
sound
opera
There
flavou
Publicidad
