Publicidad
Idiomas disponibles
Idiomas disponibles
Installing and Connecting the TV
Connecting a Satellite Receiver with a VCR
Rear of TV
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
VMC-810S/820S
(not supplied)
12
(US)
Downloaded from:
https://www.usersmanualguide.com/
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2
Connect the CATV cable to the VCR's VHF/UHF IN jack.
3
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
4
Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO
IN jacks.
5
Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
VIDEO IN 1
VIDEO IN 3
R AUDIO
L
VIDEO
S VIDEO
R AUDIO
L
R AUDIO
L
Y/G
VIDEO IN 2
S VIDEO
YC-15V/30V (not supplied)
Tips
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use TV/VIDEO on the remote to select VIDEO IN 1 to watch satellite TV or the VCR
(your VCR must be turned on). Use 0-9 and ENTER or CH +/– on the remote to watch
cable TV.
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
AUDIO OUT
R
L
DVI-HDTV
CONTROL
S
IN
P
/B
P
/R
HD
VD
B
R
OUT
SUB
VIDEO IN 4
WOOFER
75-ohm
coaxial cable
(supplied)
Satellite receiver
VHF/UHF
AC IN
YC-15V/30V
(not supplied)
VCR
Cable
Satellite
antenna
cable
VMC-
810S/820S
(not supplied)
Publicidad
