Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting Your Setup
Menu category
Screen
Control
Custom Setup
52
(US)
Downloaded from:
https://www.usersmanualguide.com/
Menu item
Setting option
Screen Zoom
Select to enlarge the picture with the center position fixed (only when "Wide Mode" is set
to "Full"). Select from "Standard" (normal size), "×2" (doubled), "×3" (tripled), or "×4"
(quadrupled).
Adjust Pixel
Select to adjust the picture from an RGB equipment.
Auto Adjust: Select "OK" to make best possible adjustment for the input signal
Dot Phase: Adjust in the range of "01" – "62" if part of a displayed text or image is not clear.
Total H Pixel (Total Horizontal Pixel): Adjust when the letter or picture is not clear as a
whole.
Reset: Reset to the factory settings.
Display
Select "On" to display which input is selected.
Screen Saver
Select to reduce image retention.
Pic. Orbit (Picture Orbit) (To prevent image retention)
Move the picture position to reduce image retention. This does not prevent image
retention completely if the same picture is displayed for an extended period of time.
Orbit: Select "On" or "Off" to set the Pic. Orbit. The factory setting is "On."
Color Matrix
Select to give the picture a neutral tint, if the output signal from the DVD player
connected to the VIDEO IN 4 jacks is 525p (480p), 1125i (1080i), or 750p (720p) signal
format. Adjust this only when the picture tint goes out of tune. Select the signal format for
each input, then set it to "Y/C
"Y/P
/P
b
RGB Mode
Select if an equipment which outputs the RGB signal is connected to the Y/G, P
jacks of the VIDEO IN 4 jacks.
DTV: Select when a digital tuner with RGB signal is connected.
Others: Select when other RGB equipment is connected.
Sync Mode
Set according to the input signal from the HD jack of the VIDEO IN 4 jacks.
H/Comp: Select when the input signal is a horizontal synchronized signal or a composite
Video: Select when the input signal is a video signal.
automatically. Note that it may not be adjusted perfectly depending on the
input signal condition or picture pattern. In this case, perform "Auto Adjust"
again.
A stop-start moving picture goes around the screen edge (one cycle per hour).
The picture shifts a little once every one to two minutes. This is because the
"Orbit" option is set to "On" to prevent image retention. When the "Orbit"
option is set to "Off," note that displaying the same patterned signals or 4.3
aspect ratio pictures for a long time may result in image retention.
/C
," or "Y/P
b
r
."
r
signal.
/P
." When purchasing, all formats are set to
b
r
/B, P
/R
B
R
Publicidad
