Velleman CTC1000 Manual Del Usuario página 12

To set a master code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Master Code and press OK.
2. Key in a 4 digit code and press OK.
3. Repeat the code and press OK.
To change a master code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Master Code and press OK.
2. Press .
3. Key in a 4 digit code and press OK.
4. Repeat the code and press OK.
To delete a master code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Master Code and press OK.
2. Press OK again.
7.8 A. Entry Time
The option A. Entry Time (away entry time) sets the countdown time you have to provide a pin code after
entering the house.
Preconditions:
Alarm status: away
•
Detection devices involved: door contact or PIR sensor set as Entry or Away Entry (see section 9.3).
•
• Action: the countdown starts when the door contact or PIR sensor is triggered.
If the pin code has not been given within the time set, the control panel will raise an alarm and send a
•
report.
Available timer options: Disable (alarm will be raised without any delay) and delays from 10 to 70 seconds.
•
Factory default is 20 seconds.
•
To access this menu item: enter Program mode, go to Gen. Settings, select A. Entry Time and press OK.
•
7.9 A. Exit Time
The option A. Exit Time (away exit time) sets the countdown time you have to leave the house when the alarm
has been set to away by the control panel, a remote control or a remote keypad.
Preconditions:
• Alarm status: set to away by the control panel, a remote control or a remote keypad
Action: the countdown starts when the alarm is set to away by the control panel, a remote control or a
•
remote keypad.
Available timer options: Disable (no exit timer will be set) and delays from 10 to 70 seconds.
•
• Factory default is 30 seconds.
• To access this menu item: enter Program mode, go to Gen. Settings, select A. Exit Time and press OK.
Notes
Pressing the Arm button on the remote control will restart the countdown timer.
•
Pressing the Disarm button on the remote control will stop the counter and disarm the alarm.
•
Entering a pin code on the control panel will stop the counter and disarm the alarm.
•
7.10 H. Entry Time
V. 04 – 11/02/2016
CTC1000
12 ©Velleman nv