Using The Alarm; Arming The System - Velleman CTC1000 Manual Del Usuario

9. Press OK to finish.
GSM Signal
The option GSM signal allows monitoring the signal strength.
1. On the control panel, enter Program mode, go to GSM signal and press OK.
The system will display the signal strength (from 0 to 9, 9 being the strongest signal).
Walk Test
The option Walk Test checks the communication between the control panel and any device.
1. On the control panel, enter Program mode, go to Walk Test and press OK.
2. Press the Test button on the device you want to test.
If the control panel receives a signal, it will display the device's name, zone and signal strength.
3. Press to exit.
Reset GSM
The option Reset GSM resets the mobile phone signal.
1. On the control panel, enter Program mode, go to Reset GSM and press OK.
The signal takes about 1 minute to reset.

11. Using the alarm

When the alarm is disarmed (off), enter a pin code to access the user menu. From this menu, you can set the
alarm on or off.
Enter the first digit of your pin code.
1. Within 10 seconds, enter the other digits of the pin code. The display shows:
2. The cursor blinks next to Away Arm. The full menu contains the following items:
If the system has detected an error, the first line of the display will show:

11.2 Arming the system

If the system is disarmed, you can arm it as follows:
V. 04 – 11/02/2016
CTC1000
26 ©Velleman nv