Velleman CTC1000 Manual Del Usuario página 13

The option H. Entry Time (home entry time) sets the countdown time you have to enter the house when the
system is set in Home mode.
Preconditions:
• Alarm status: home mode
• Detection devices involved: door contact or PIR sensor set as Entry or Home Access (see section 9.3).
Action: the countdown starts when the door contact or PIR sensor is triggered.
•
If the pin code has not been given within the time set, the control panel will raise an alarm and send a
•
report.
• Available timer options: Disable (alarm will be raised without any delay) and delays from 10 to 70 seconds.
• Factory default is 20 seconds.
• To access this menu item: enter Program mode, go to Gen. Settings, select H. Entry Time and press OK.
7.11 H. Exit Time
The option H. Exit Time (home exit time) sets the countdown time you have to leave the house when the
system is set in Home mode.
Preconditions:
Alarm status: set to away by the control panel, remote control or remote keypad
•
• Action: the countdown starts when the alarm is set to away by the control panel, a remote control or a
remote keypad.
Available timer options: Disable (no exit timer will be set) and delays from 10 to 70 seconds.
•
Factory default is 30 seconds.
•
To access this menu item: enter Program mode, go to Gen. Settings, select H. Exit Time and press OK.
•
Notes
Pressing the Home button on the remote control will restart the countdown timer.
•
Pressing the Disarm button on the remote control will stop the counter and disarm the alarm.
•
Entering a pin code on the control panel will stop the counter and disarm the alarm.
•
7.12 Door Chime
The option Door Chime sets the door chime on or off while a door contact or PIR sensor is activated in alarm off
mode.
Preconditions:
• Alarm status: off
• Detection devices involved: door contact or PIR sensor set as Entry or Away Entry (see section 9.3).
Action: The control panel sounds a door chime while the door contact or PIR sensor is activated in alarm off
•
mode.
Factory default is off.
•
To access this menu item: enter Program mode, go to Gen. Settings, select Door Chime and press OK.
•
7.13 Time
The option Time allows setting the current time.
1. To access this menu item: enter Program mode, go to Gen. Settings, select Time and press OK.
2. Use the up and down arrows to set the hours and press OK.
3. Use the up and down arrows to set the minutes and press OK.
V. 04 – 11/02/2016
CTC1000
13 ©Velleman nv