Velleman CTC1000 Manual Del Usuario página 23

1. Use the up and down arrows to select a device and press OK.
You can now change the device attribute. To skip this step, press
2. Use the up and down arrows to select an attribute and press OK.
3. Press OK to confirm.
You can now change the device name. To skip this step, press
4. Enter a zone name and press OK.
The display returns to the device list. Use the up and down arrows to select another device or press
Edit a remote keypad – water sensor
1. Enter Program mode, go to Devices+/-, select Edit devices and press OK.
The display lists all the devices available.
2. You can now change the device name.
3. Enter a zone name and press OK.
The display returns to the device list. Use the up and down arrows to select another device or press
9.5 Remove a device
1. Enter Program mode, go to Devices+/-, select Remove device and press OK.
The system lists all available devices.
2. Use the up and down arrows to select a device and press OK.
For details about the available working modes, see section 9.3.
V. 04 – 11/02/2016
CTC1000
.
. To continue, press OK.
23
.
.
©Velleman nv