Publicidad
Assemble and Position
Supports
E (2)
K (6)
X (4)
Y (4)
1. Pivot the head of each of the four
supports (E and F) 90° to form a "T".
See Figure 10.
2. Add second screw (Y) and nut (X) to
each support. It may be necessary to
loosen existing screw. Tighten all nuts
securely when done. See Figure 10.
NOTE: There is an interference fit
between the square screw neck and
the support head. Use hammer to
seat bolt in support, if necessary.
F (2)
Hole
3. Install supports as shown in Figure
11.
NOTE: Supports are placed so they
align when viewed from the end of the
stand.
NOTE: Two of the supports (F) have
cross-holes in the support posts. These
holes are used to position the edge
guide and stop bars. Place the
supports with cross holes in telescoping
extensions. See "Install Edge Guide
and Stop Bar," page 13.
12
Figure 10
Figure 11
Publicidad
Capítulos
