Publicidad
SAFETY INSTRUCTIONS
Safety items throughout this manual are labeled with WARNING and CAUTION.
Means that failure to follow this safety statement may result in
WARNING
extensive product damage, serious personal injury, or death.
Means that failure to follow this safety statement may result in minor
CAUTION
or moderate personal injury, or property or equipment damage.
WARNING
READ ALL SAFETY INSTRUCTIONS
BEFORE USING
Read the owner's manual carefully. Learn
its applications and limitations as well as the
specific potential hazards.
DO NOT USE FOR SCAFFOLDING OR AS
LADDER
DO NOT OVERLOAD
Maximum capacity for the center section of
the miter saw stand is 500 lbs.
DO NOT APPLY AN UNBALANCED LOAD
This could cause the miter saw stand to tip
over.
CHECK DAMAGED PARTS
Before further use of the tool, any part that is
damaged should be carefully checked to
ensure that it will operate properly and
perform its intended function. Check for
alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other conditions that may affect its
operation. A part that is damaged should be
properly repaired or replaced.
NEVER LEAVE TOOL RUNNING
UNATTENDED
Turn power off. Do not leave tool until it
comes to a complete stop. When not in use,
remove tool from the stand. Do not leave
your tool unattended when mounted to your
stand.
USE CARE WHEN USING POWER TOOLS
When using a power tool with the miter saw
stand, ALWAYS follow the safety instructions
in the power tool's owner's manual. ALWAYS
wear safety glasses or eye shields when
operating power tools.
DO NOT STAND OR CLIMB ON MITER SAW
STAND
It could fall or tip over, causing serious injury.
ENGAGE ALL LOCKING PINS
All leg locking pins must be engaged into the
set-up position holes before using your miter
saw and miter saw stand.
DRESS FOR SAFETY
Do not wear loose clothing, gloves, neckties,
or jewelry, as these items can get caught and
draw you into moving parts. ALWAYS wear
non-slip footwear. Tie back long hair. Roll
long sleeves above the elbow.
FIRMLY ATTACH MITER SAW
DO NOT attempt to use your miter saw stand
unless the miter saw is fastened firmly to your
boards.
USE YOUR MITER SAW STAND ON A
HARD, DRY, FLAT SURFACE ONLY
DISCONNECT TOOLS BEFORE SERVICING
When changing accessories such as blades,
bits, cutters, etc., make sure tool is unplugged.
3
Publicidad
Capítulos
