Publicidad
Idiomas disponibles
Idiomas disponibles
6.3
Driving a fastener
WARNING
Risk of injury by incorrect handling and/or splintering material!
▶ Risk of driving a nail through your hand! Always use both hands to operate the product! Always hold
the product firmly with your second hand as illustrated.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body!
By unintentionally triggering a driving operation, this can cause severe injury.
▶ Wear personal protective equipment and always wear protective glasses and protective gloves.
Other persons in the vicinity must also wear eye protection and a hard hat. When fasteners are being
driven, there is a risk of injury to the body and eyes caused by material splintering off the working surface
and also if there are foreign bodies in the area of the fastener guide.
▶ Never attempt to clear malfunctions of the tool by continuing to trigger the tool!
CAUTION
Risk of injury and damage to the fastening tool!
▶ Never attempt to re-drive the fastener! This can lead to fastener breakages and jamming of the
fastener.
▶ Use only approved, genuine Hilti accessories with this tool.
accessories can lead to injuries and damage the fastening tool.
1. Switch on the fastening tool. → page 8
2. Insert the fastener.
3. Hold the fastening tool perpendicular to the working surface and press it against the surface, pushing
the fastener guide in as far as it will go.
4. Drive the fastener by pulling the trigger.
After driving each fastener, use the test gauge to check that the stud has been driven to the correct
preset depth.
5. Lift the fastening tool completely clear of the working surface after driving a fastener.
•
The fastening tool switches itself off automatically if the fastener guide is pressed against the
working surface for longer than 6 seconds without a fastener being driven. The fastening tool
can be switched on again by pressing the on/off button.
Never attempt to re-drive the fastener!
•
The fastening tool switches itself off automatically if it is not used for 6 minutes.
7
Care and maintenance
7.1
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
•
Switch off the fastening tool.
•
Remove the battery.
•
Remove the fastener from the fastener guide.
•
Carefully remove any dirt that may be adhering to parts.
•
Clean the air vents carefully with a dry brush.
•
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the lithiumion batteries
•
Keep the battery free from oil and grease.
•
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
•
Avoid ingress of moisture.
*2338837*
4
2338837
The use of unsuitable material and
English
9
Publicidad
