BTI PROFILINE A-SBS 36V LI Manual Original página 34

OBJ_BUCH-888-001.book Page 34 Thursday, February 19, 2009 12:55 PM
Tips
After longer periods of working at low speed, allow
the machine to cool down by running it for approx.
3 minutes at maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS
drill bits (HSS=high-speed steel). The appropriate
quality is guaranteed by the BTI accessories program.
Before screwing larger, longer screws into hard mate-
rials, it is advisable to predrill a pilot hole with the core
diameter of the thread to approx.
length.
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between 0 °C and 45 °C. As an example, do not leave
the battery in the car in summer.
Occasionally clean the venting slots of the battery
using a soft, clean and dry brush.
A significantly reduced working period after charging
indicates that the battery is used and must be
replaced.
Observe the notes for disposal.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as dur-
ing transport and storage, remove the battery
from the power tool. There is danger of injury
when unintentionally actuating the On/Off switch.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for BTI
power tools.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
Replacing the Carbon Brushes (see figure H)
When the carbon brushes are worn, the power tool
switches off automatically. For replacement of the car-
bon brushes, unscrew the screws of the cover lids 18
and remove the cover lids 18. Insert a screwdriver or
similar into the notch of the brush holder 19 and and
carefully pry it out. Remove the used carbon brushes
and replace them. The new carbon brushes can also
be inserted when turned by 180°. Lightly press the
inserted carbon brushes downward until they can be
clearly heard to engage. Afterwards mount the cover
lids 18 again.
34 | English
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
2
/ of the screw
3
tools that are no longer usable must be collected sep-
arately and disposed of in an environmentally correct
manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 91/157/EEC.
Batteries no longer suitable for use can be directly
returned at:
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: SPT-Technical.de@de.bosch.com
Subject to change without notice.
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
2 609 932 668 • 19.2.09