NORAUTO 2382382-NO3176 Manual página 19

EXPLANATION OF SYMBOLS
EN
PART LIST
1. 4.3" TFT LCD MONITOR
2. Rear camera with plate
holder
3. Wireless transmitter
4. Wireless receiver
5. Power cable for the monitor
INSTALLATION AND TESTING
Notes:
• The unit is simple to install in your vehicle. However, we recommend that you have a
licensed auto electrician install it to ensure that you do not damage your vehicle.
• To correctly connect the unit to your vehicle's battery, we recommend you use a licensed
auto electrician. Norauto is not responsible for any shorts, battery damage, fire or other
issues arising from incorrect installation of the unit.
1. Put your vehicle's license plate into the plate holder and then fix the plate holder on the
back of your vehicle. Then connect the wireless transmitter to the rear camera using the
red and yellow plugs as shown in the diagram below. Finally, connect the power supply
wires (A) of the wireless transmitter to the power supply wires of a reversing light.
18
Compliance with the relevant requirements of the EU Directive(s).
Selective collection of waste electrical and electronic equipment.
Electrical equipment must not be disposed of with household waste.
Pursuant to European Directive 2012/19/EU on waste electrical and
electronic equipment, and its transposition into national law, waste
electrical equipment must be collected separately and disposed of in
designated collection points. Contact the local authorities or the vendor for
advice on recycling.
Transmitter
1
3
Video (Yellow)
Power (Red)
Camera
2
4 5