Descargar Imprimir esta página

Progress Lighting AirPro P250098 Manual De Instalación página 10

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

Finishing the Installation
Step 1. Tuck connections neatly into ceiling outlet
box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until it
locks in place at the narrow section of the key
holes. (Fig. 11)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws. NOTE: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger ball before
attaching the canopy to the bracket by turning the
housing until it drops into place.
7.
Outlet box
Hanger
bracket
Canopy
cover
Figure 11
Attaching the Fan Blades
Attaching the blades to the blade arms
Step 1. Attach the blades and blade support plates
to the blade arms using the three blade attachment
screws with lock washers provided. Start a screw
with lock washer into the blade arms, but do not
tighten. (Fig. 12)
Step 2. Repeat for the two remaining blade
attachment screws with lock washers.
Step 3. Tighten each screw securely starting with
the center screw. Make sure the blade is straight.
Step 4. Attach the decorative rod holders and
decorative rod holder support plates to the blades
using the two decorative rod holder attachment
screws with lock washers. (Fig. 12)
Step 5. Tighten each screw securely starting and
make sure the blade is straight.
Screws
Step 6. Repeat these steps for the remaining blades.
Canopy
Blade arms
Blade screws
with lock washers
Figure 12
Decorative rod
holders
Blades
Decorative
rod holder
Decorative
support
rod holder
plates
screws with
lock washers
Blade
support
plates

Publicidad

loading

Este manual también es adecuado para:

Airpro p250098-081