Make the Electrical
Connections
WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse
box before wiring.
WARNING: Check to see that all connections are
tight, including ground, and that no bare wire is
visible at the wire nuts, except for the ground
wire.
CAUTION: To reduce the risk of electric shock,
this fan must be installed with an isolating wall
control/switch.
NOTE: The fan must be installed at a maximum
distance of 20 ft. from the remote control for
proper signal transmission between the remote
control and the fan's receiving unit.
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan to your
household wiring. Use the plastic wire nuts with
your fan. Secure the plastic wire nuts with
electrical tape. Make sure there are no loose
strands or connections.
Step 1. Insert the receiver into the mounting
bracket with the flat side of the receiver facing
the ceiling.
Step 2. Make wire connections from the fan to
the receiver.
From Fan
To Receiver
-------------
White Wire
White Wire "For Light"
Blue Wire
--------------
Blue Wire "For Light"
-----------
Yellow Wire
Yellow Wire
Red Wire
---------------
Red Wire
--------------
Grey Wire
Grey Wire
Step 3. Make wire connections from the filter to
the outlet box as follows, using the wire nuts.
From Filter
To Outlet Box
Black Wire "AC in L"
-----
Black Wire (Hot)
-----
White Wire "AC in N"
White Wire (Neutral)
From Fan, Filter
To Outlet Box
& Receiver
Green Wires*
-------------
Green or Bare Wire
(Ground)
* There are four green grounding leads: from the
mounting bracket, hanger ball/downrod assembly,
receiver and the filter.
Step 4. Turn the wire nut connections upward,
spreading them apart so the green (ground) and
white wires will be on one side of the outlet box
and the black and blue wires will be on the other
side. Carefully tuck the connections up into the
outlet box.
White
Black
Outlet Box
White
Black
Filter
White
Black
Receiver
White
Blue
Yellow
Red
Grey
Grey
Red
Yellow
Blue
White
Canopy
Figure 10
Ground conductor
Green
Green
Green
Green
Green
6.