Publicidad
Idiomas disponibles
Idiomas disponibles
Your DC brushless motor is equipped with an
automatically learned type remote control. There
is no frequency switches on the receiver or
transmitter. The fan can start to use once the
pairing process is done.
Remote Control Button Definitions:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
button: Turns the fan off.
button: Controls fan direction.
button: This button is to control optional light on or
off. Press and hold the button to activate the dimmer
function.
Setting the Remote Control
Follow the below steps to set the remote control:
The auto learning function will only mandate
within 60 seconds when turning the fan's AC
power ON.
With the fan's power off, restore power to the fan.
Press and hold "SET" button for about 5 seconds and
release. If optional light kit is installed, the light kit
will flash twice and the signal light on the remote
11. Operating Your Transmitter
control will come on when the button is pressed.
The fan has completed the pairing process with
the remote control and is ready for use.
NOTE: If the self calibration test failed, turn the
AC power off; restore power and process the self
calibration test again.
NOTE: During self calibration test, the remote is
non-fuctional.
NOTE: The learning frequency function and self
calibration test will continue to retain the last set
frequency and calibration set even when the AC
power is shut off. If the frequency is changed the
self calibration test will occur again.
Over 80W protection: When the receiver detects
motor power consumption which is greater than
80W, the receiver power will be stopped and
operation will immediately discontinue. Wait for
5 seconds and then turn the receiver power back
on.
Figure 18
Figure 19
Publicidad
