Publicidad
Idiomas disponibles
Idiomas disponibles
3.1.5 DRYING FUNCTION
This function provides air for drying after the
cleaning functions. While using this function
it is possible to adjust:
•
Air temperature
•
Air pressure: It can be adjusted at
three levels. By default it is activated
in medium setting. It can be increased
(turbo)
temperature
To turn off this function press the Stop button
on the remote control or the auxiliary side
control.
The drying stops after 5 minutes if no other button is pressed.
If another function is selected while the drying is on, the drying
stops and the selected function is activated.
The parameters of this function can be modified through the
APP.
3.1.7 FLUSHING
The flushing buttons allow to perform a
FULL
4,5L
full flush of the water tank, a half flush, a
HALF
night (or silent) flush, and a full flush with
3L
cleaning agent (hygienic flush).
The Night Flush flush, or silent flush, is
performed by pressing the full flush and half
flush buttons together on the remote control.
HYGIENIC
By default, the autoflush mode is on.
FLUSH
•
It can be deactivated by pressing the full flush button
on the remote for longer than 3 seconds. A long 'beep'
indicates that the autoflush has been deactivated.
•
To set the autoflush on again press the full flush button
on the remote for longer than 3 seconds. Two long
'beeps' will indicate that the autoflush is active again.
An automatic pre-flush when the user is detected can be
set. In this case, a 1L flush will be performed. To activate or
deactivate this function, the half flush button on the remote
must be pressed for longer than 5 seconds.
The parameters of this function can be modified through the
APP.
or
decreased
(silent)Air
3.1.6 STOP FUNCTION
It stops washing and drying functions.
3.1.8 SEAT AND LID OPENING
The seat and lid can be opened by pressing
the Buttons on the remote or can be set
to autoopen and autoclose. In case of
autoopen, the seat will open automatically
OPEN
when the user is detected. In case of
CLOSE
autoclose the lid will close automatically 10
sec after the user leave the toilet.
To set the autoopen again press the lid open
button on the remote for longer than 5 sec,
in this case two long 'beeps' will indicate that
is active.
By default the autoclose mode is activated.
It can be deactivated by pressing the lid close button on the
remote for longer than 5 sec. A long 'beep' indicates that it
has been deactivated.
To set the autoopen again press the lid close button on the
remote for longer than 5 sec, in this case two long 'beeps' will
indicate that is active.
The parameters of this function can be modified through the
APP.
37
Publicidad
