Bosch Kiox BUI330 Instrucciones De Servicio Originales página 13

Fitting and removing the on-board
computer (see figure A)
Fit the lower part of the Kiox into the holder (5) first
and tilt it forward gently until you can feel that the on-
board computer is firmly fixed in the magnetic holder.
To remove the on-board computer, hold it by the top
end and pull it toward you until it disengages from the
magnetic holder.
When you park up the eBike, remove the on-
u
board computer.
Before initial commissioning
The Kiox is supplied with a partially charged battery.
Before using it for the first time, this battery must be
charged for at least one hour via the USB port (see
"Energy supply of the on-board computer",
page English – 12) or via the eBike system.
The control unit should be attached such that the but-
tons are almost perpendicular to the handlebars.
When turning on the on-board computer for the first
time, the language selection is displayed and then you
can use the menu item <Intro to Kiox> to find out
more about the main functions and displays. You can
access this menu item again at a later time via <Set-
tings> → <Information>.
Selecting system settings
Fit the on-board computer in the holder and proceed
as follows while the bicycle is stationary:
Go to the status page (use the < button (10) on the
operating unit to get to the first display) and open the
<Settings> with the select button (9).
You can use the – (11) and + (12) buttons to select
the setting you want. You can open the settings, as
well as any additional submenus, using the select but-
ton (9). You can use the button < (10) to go back to
the previous menu from any settings menu.
The following settings can be changed in the <Sys
settings>:
– <Brightness>
Bosch eBike Systems
The on-board computer can be secured in place to
prevent it from being removed from the holder. To do
this, loosen the headset screw (16) until the Kiox
holder can be swiveled sideways. Put the on-board
computer in the holder. Screw the locking screw (M3,
6 mm long) from below into the thread provided in
the on-board computer (using a longer screw may
damage the on-board computer). Swivel the holder
back into place and tighten the headset screw in ac-
cordance with the manufacturer's specifications.
Operation
– <Time>
– <Date>
– <Time zone>
– <24h format>
– <Bright background>
– <Imperial units>
– <Language>
– <Factory reset>
Starting Operation of the eBike
Requirements
The eBike can only be activated when the following
requirements are met:
– A sufficiently charged eBike battery is inserted (see
operating instructions for the eBike battery).
– The on-board computer is properly inserted in the
holder.
Switching the eBike on/off
The following options are available for switching on
the eBike:
– Once the on-board computer and the eBike battery
are fitted, briefly press the on/off button (4) on the
on-board computer.
– With the on-board computer inserted, push the on/
off button on the eBike battery (bicycle manufac-
turer-specific solutions are possible when there is
no access to the eBike battery on/off button; see
the eBike battery operating instructions).
English – 11
1 270 U20 XBK | (14.03.2023)