Bosch Kiox BUI330 Instrucciones De Servicio Originales página 19

The a ... d indicators form the status bar and are
shown on every page. If the speed is already being
displayed on the screen itself, the a indicator will
change to the current time in hours and minutes. The
status bar displays:
– Speed/time: The current speed in km/h or mph or
the current time
– Assistance level: Indicates the current level of as-
sistance using a color code
– Light: A symbol that indicates whether the light is
on
– eBike battery state of charge: Indicates the cur-
rent state of charge as a percentage
The performance evaluation l graphically displays
your current speed in comparison to your average
speed k.
– Indicator in orange area (left side): Below your av-
erage speed
– Indicator in green area (right side): Above your av-
erage speed
– Indicator in the middle: Corresponds to your aver-
age speed
The navigation bar h indicates which page you are on.
Your current page is highlighted. You can use the
< (10) and > (8) buttons to move to additional pages.
From the initial start page, you can access the status
page via the < (10) button.
Status screen
73%
0 0 .
09:57
73% 98%
N/A
Good connection
Poor connection
No connection
Bosch eBike Systems
As well as the status bar,
the status page also
shows you the current
time and the state of
charge of all your eBike's
batteries, as well as the
state of charge of your
smartphone battery if the
smartphone is connected
via Bluetooth®.
You will also be shown the date of the most recent
synchronization between the smartphone and Kiox.
You can access the <Settings> from the bottom sec-
tion.
<Settings>
You can access the settings menu via the status page.
The <Settings> cannot be accessed or changed
while riding.
You can use the – (11) and + (12) buttons to select
the setting you want. You can open the settings, as
well as any additional submenus, using the select but-
ton (9). You can use the button < (10) to go back to
the previous menu from any settings menu.
You can find the following superordinate sections on
the first navigation level:
– <Registration> – Registration notification:
This menu item is only shown if you have not yet
registered on eBike Connect.
– <My eBike> – Settings for your eBike:
You can reset the counters (such as the number of
kilometers traveled that day or average values) to
zero either automatically or manually, and you can
reset the range. You can change the wheel circum-
ference value that was preset by the manufacturer
by ±5 %. If your eBike features eShift, you can also
configure your eShift system here. The bicycle
manufacturer or dealer may base the service date
on the distance traveled and/or a period of time.
The due date for the service is displayed under
<Next Service: ...>. The bike component page dis-
plays the serial number and hardware and software
versions for each component, in addition to other
key data that is relevant for the components.
– <Screens> Here you can set the content and order
of the screens, and reset these to factory settings if
required.
– <Bluetooth> – Switching the Bluetooth® function
on or off: Connected devices, for example heart
rate monitors, are displayed.
– <My profile> – Active user data:
Is only displayed if the user is registered.
English – 17
1 270 U20 XBK | (14.03.2023)