Bosch Kiox BUI330 Instrucciones De Servicio Originales página 15

You can deactivate storage mode by pressing the on/
off button (4) for at least two seconds.
The on-board computer detects whether it is in fully
working order. If you press and hold the on/off but-
ton (4) for at least eight seconds while the on-board
computer is in fully working order, it will go into stor-
age mode. If, contrary to expectations, the Kiox is not
in a fully functional condition and cannot be operated,
pressing and holding the on/off button (4) (for at
least eight seconds) will reset it. After being reset,
the on-board computer will restart automatically after
approx. five seconds. If the Kiox does not restart,
press the on/off button (4) for two seconds.
To reset the Kiox to its factory settings, select <Set-
tings> → <Sys settings> → <Factory reset>. All
user data will be lost.
Battery charge indicator of the eBike
battery
The battery charge indicator of the eBike bat-
tery d (see "Start page", page English – 16) can be
read on the status page and in the statusbar. The
eBike rechargeable battery's state of charge is also in-
dicated by the LEDs on the eBike rechargeable bat-
tery itself.
Color of the indicator
Green
Orange
Red
Red + !
Bosch eBike Systems
Meaning
The eBike rechargeable
battery is over 30 %
charged.
The eBike rechargeable
battery is charged be-
tween 15 % and 30 %.
The eBike rechargeable
battery is charged be-
tween 0 % and 15 %.
The capacity for assisting
the drive has been used
up, and assistance is
switched off. The remain-
ing capacity will be pro-
vided for the bike lights
Color of the indicator
If the eBike battery is being charged on the eBike, a
corresponding notification will be displayed.
If the on-board computer is removed from the
holder (5), the state of charge that was last displayed
for the eBike rechargeable battery is saved.
Setting the assistance level
On the operating unit (7), you can set the level of as-
sistance you want the eBike drive to provide you with
while pedaling. The assistance level can be changed
at any time, even while cycling.
Note: In some models, the assistance level may be
preset and cannot be changed. There may also be
fewer assistance levels available than stated here.
The following assistance levels are available as a max-
imum:
– OFF: Drive assistance is switched off. The eBike
can only be moved by pedaling, as with a normal bi-
cycle. The push assistance cannot be activated at
this assistance level.
– ECO: Effective assistance with maximum effi-
ciency, for maximum range
– TOUR/TOUR+:
TOUR: Steady support, for long-range touring
TOUR+: Dynamic support for natural and sporty
driving (only in conjunction with eMTB)
– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking
and for cycling in urban traffic
eMTB: Optimum assistance whatever the terrain,
rapid acceleration when starting from a standstill,
improved dynamics, top performance (eMTB is
only available in combination with drive units
BDU250P CX, BDU365, BDU450 CX and BDU480
CX. This also requires a software update.)
– TURBO: Maximum assistance even at high ca-
dences, for biking sports
To increase the assistance level, press the + (12)
button on the operating unit repeatedly until the de-
English – 13
Meaning
and the on-board com-
puter.
1 270 U20 XBK | (14.03.2023)