Bosch Kiox BUI330 Instrucciones De Servicio Originales página 14

English – 12
The drive is activated as soon as you start pedaling
(except for in the push assistance function or with the
assistance level OFF). The drive output depends on
the settings of the assistance level.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
20/28 mph, the drive switches off the assistance.
The drive is automatically re-activated as soon you
start pedaling again and the speed is below
20/28 mph.
The following options are available for switching off
the eBike:
– Briefly press the on/off button (4) of the on-board
computer.
– Switch off the eBike battery using its on/off button
(bicycle manufacturer-specific solutions are possi-
ble when there is no access to the eBike battery on/
off button; see the bicycle manufacturer operating
instructions).
– Remove the on-board computer from its holder.
If no power is drawn from the drive for about 10 min-
utes (e.g. because the eBike is not moving) and no
button is pressed on the on-board computer or the
operating unit of the eBike, the eBike will switch off
automatically.
Energy supply of the on-board computer
If the on-board computer is in the holder (5), a suffi-
ciently charged eBike battery is inserted into the
eBike and the eBike is switched on, then the on-board
computer's internal battery is powered and charged
by the eBike battery.
If the on-board computer is removed from the
holder (5), the power is supplied by the on-board
computer's internal battery. If the charge of the on-
board computer's internal battery is running low, a
warning message appears on the display.
To charge the on-board computer's internal battery,
slide the on-board computer back onto the
holder (5). Note that if you do not charge the eBike
battery straight away, the eBike will automatically
switch off after ten minutes of inactivity. If this hap-
1 270 U20 XBK | (14.03.2023)
pens, the on-board computer's internal battery will
also stop charging.
You can also charge the on-board computer via the
USB port (6). To do this, open the protective
cap (17). Use a Micro USB cable to connect the USB
port on the on-board computer to a commercially
available USB charger (not included with the product
as standard) or to the USB port of a computer (max.
5 V charging voltage; max. 1000 mA charging cur-
rent).
If the on-board computer is removed from the holder
(5), all values of the functions are saved and are still
displayed.
Following use, the USB port must be carefully re-
sealed with the protective cap (17).
If the on-board computer's internal battery is not
recharged, the date and time will be retained for up to
6 months. When the on-board computer is switched
on again, the date and time will be reset if a
Bluetooth® connection to the app has been estab-
lished and the smartphone has successfully identified
the current location via GPS.
Note: The Kiox only charges while it is switched on.
Note: If the Kiox is switched off during charging via a
USB cable, the Kiox can only be switched on again
once the USB cable has been disconnected.
Note: To maximize the service life of the on-board
computer's internal battery, it should be recharged
for one hour every three months.
Resetting Storage Mode/Kiox
The on-board computer has an energy-saving storage
mode which minimizes the rate at which the internal
battery discharges. Setting to this mode erases the
date and time.
This mode can only be activated by pressing and
holding the on/off button (4) of the on-board com-
puter (for at least eight seconds).
If the on-board computer does not start when the on/
off button (4) is pressed briefly, the on-board com-
puter is in storage mode.
Bosch eBike Systems