Bosch Kiox BUI330 Instrucciones De Servicio Originales página 7

Robert Bosch GmbH, Bosch eBike Systems is un-
der license.
The on-board computer is fitted with a radio in-
u
terface. Local operating restrictions, e.g. in air-
planes or hospitals, must be adhered to.
Do not enter information or make selections
u
while riding. Interacting with the display unit while
riding can lead to accidents causing serious injury
or death. You must observe road and traffic condi-
tions, and comply with traffic laws at all times.
Using your mobile device while operating an
u
eBike may be distracting. Distracted driving is a
serious safety concern and can lead to accidents
causing serious injury or death. In order to pre-
vent distracted driving, most devices come
equipped with a "Do Not Disturb" mode. The "Do
Not Disturb" mode should be used while operat-
ing an eBike. Please consult your device-specific
instructions for more information. You, as the eBike
operator, are fully responsible for ensuring that you
pay attention to road conditions and comply with
traffic laws at all times.
Do not activate push assistance function while
u
riding on the bike. Only use push assitance func-
tion when pushing the eBike.
Please note that certain State or local laws may re-
u
quire that class III eBikes must be equipped with a
functioning speedometer that displays speed in
miles per hour. Riders must be aware of any and all
applicable rules and regulations related to the oper-
ation or use of class III eBikes in any applicable ju-
risdictions before operating or otherwise using this
product.
Safety Warnings for charging the on-board
computer battery
Only charge the on-board computer with USB
u
power source (5 V, 1000 mA max) and USB ca-
ble rated at least 1000 mA. Using USB power
source or USB cable not appropriately rated for the
application may result in fire, explosion or personal
injury.
Bosch eBike Systems
Charge the on-board computer in temperatures
u
above +32 degrees F (0 degrees C) and below
+104 degrees F (40 degrees C). Store on-board
computer in locations where temperatures will
not exceed 104 degrees F (40 degrees C). This is
important to prevent serious damage to the battery
in the on-board computer.
Do not expose on-board computer to fire or ex-
u
cessive temperature. Exposure to fire or tempera-
ture above 212 °F (100 °C) may cause explosion.
Do not recharge the on-board computer (via
u
USB port) in damp or wet environment. Water
entering on-board computer may result in electric
shock or fire.
Never submerge on-board computer in fluid of
u
any kind or allow fluid to enter them. Corrosive
or conductive fluid (such as seawater or industrial
chemical or bleach containing products, etc.) can
cause short circuit which may result in fire, per-
sonal injury and property damage.
Battery leakage may occur under extreme usage
u
or temperature conditions. Avoid contact with
skin and eyes. The battery liquid is caustic and
could cause chemical burns to tissues. If liquid
comes in contact with skin, wash quickly with soap
and water. If the liquid contacts your eyes, immedi-
ately flush eyes with water for a minimum of
15 minutes and seek medical attention.
Place on-board computer on flat nonflammable
u
surfaces and away from flammable materials
when recharging on-board computer using ex-
ternal USB power source. Carpeting and other
heat insulating surfaces block proper air circulation
which may cause overheating of the on-board com-
puter. If smoke or melting of the on-board com-
puter is observed, unplug the external USB power
source immediately and do not use the on-board
computer. Contact customer service immediately.
Before each use, check the on-board computer,
u
cable and plug. If damage is detected, do not use
the on-board computer. Damaged on-board com-
English – 5
1 270 U20 XBK | (14.03.2023)