Publicidad
Idiomas disponibles
Idiomas disponibles
2. SEQUENTIAL TRIP OPERATION:
A. Press the contact trip against the work surface, without touching the trigger.
THE TOOL MUST NOT CYCLE.
B. Hold the tool off the work surface and pull the trigger.
THE TOOL MUST NOT CYCLE.
C. Pull the trigger and press the contact trip against the work surface.
THE TOOL MUST NOT CYCLE.
D. With finger off the trigger, press the contact trip against the work surface. Pull the trigger.
THE TOOL MUST CYCLE.
When working on air tools, note the warnings in this manual and use extra care evaluating
problem tools.
REPLACEMENT PARTS:
Use only genuine BOSTITCH replacement parts. Do not use modified parts.
ASSEMBLY PROCEDURE FOR SEALS:
When repairing a tool, make sure the internal parts are clean and lubricated. Use Parker "O"-LUBE, Magnalube, or equivalent on all "O"-rings.
Coat each "O"-ring with lubricant before assembling.
AIR SUPPLY-PRESSURE AND VOLUME:
Air volume is as important as air pressure. The air volume supplied to the tool may be inadequate because of undersize fittings and hoses, or
from the effects of dirt and water in the system. Restricted air flow will prevent the tool from receiving an adequate volume of air, even though
the pressure reading is high. The results will be slow operation, misfeeds or reduced driving power. Before evaluating tool problems for
these symptoms, trace the air supply from the tool to the supply source for restrictive connectors, low points containing water and anything
else that would prevent full volume flow of air to the tool.
MAINTAINING THE PNEUMATIC TOOL
-13-
Publicidad
