Descargar Imprimir esta página

Porter Cable PC1801D Manual De Instrucciones página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

oPeRAtING INStRuctIoNS
tRIGGeR SWItcH & foRWARd/ReveRSe
ButtoN - fIGuRe e
The drill is turned ON and OFF by pulling and
releasing the trigger switch (1) shown in
figure e. The farther the trigger is depressed,
the higher the speed of the drill. A forward/
reverse control button (2) determines the
direction of the tool and also serves as a lock
off button. To select forward rotation, release
the trigger switch and depress the forward/
reverse control button. To select reverse,
depress the forward/reverse control button
in the opposite direction. The center position
of the control button locks the tool in the off
position. When changing the position of the control button, be sure the trigger is released.
AdjuStING toRQue coNtRol - fIGuRe f
This tool is fitted with a torque adjustment
collar (3) to select the operating mode and
to set the torque for tightening screws. Large
screws and hard workpiece materials require
a higher torque setting than small screws and
soft workpiece materials.
• For drilling in wood, metal and plastics,
set the collar to the drilling position
symbol
• For screwdriving, set the collar to the
desired setting. If you do not yet know the
appropriate setting, proceed as follows:
• Set the collar to the lowest torque setting.
• Tighten the first screw.
• If the clutch ratchets before the desired
result is achieved, increase the collar setting and continue tightening the screw.
Repeat until you reach the correct setting. Use this setting for the remaining screws.
duAl RANGe GeARING - fIGuRe G
The dual range feature of your drill allows
you to shift gears for greater versatility.
To select low speed, high torque setting
(position 1), turn tool off and permit to stop.
Slide gear shifter button (4) away from the
chuck. To select the high speed, low torque
setting (position 2), turn tool off and permit to
stop. Slide gear shifter button back (towards
the chuck).
Note: Do not change gears when tool is
running. If you are having trouble changing
gears, make sure that the dual range gear
button is either completely pushed forward or
completely pushed back.
E
F
G
9
2
1
3
4

Publicidad

loading