GreenWorks UltraPower PH60L210 Manual Del Operador página 33

14 TROUBLESHOOTING
PROBLEM POSSIBLE
CAUSE
The battery pack is
The motor does
not installed tight-
not start when
ly.
you pull the trig-
ger.
The battery pack is
out of power.
The power switch
is defective.
The machine does The motor is defec-
not start. tive.
The PCB board is
defective.
The air does not
The air inlet or
flow through the
tube outlet has a
tube when you
blockage.
start the machine.
15 TECHNICAL DATA
Voltage 60 V
Air volume 610 CFM
Air speed 130 MPH
Weight (without 5.3 lbs. (2.4 kg)
battery pack)
Battery model LB602, LB6025, LB603, LB604,
LB605, LB606 and other BAC series
Charger model CAC801, CH60DP01, 60DPC10A,
CH60R00 and other CAC series
The recommended ambient temperature range:
Item
Blower storage temperature
range
Blower operation tempera-
ture range
Battery charging temperature
range
Charger operation tempera-
ture range
Battery storage temperature
range
Battery discharging tempera-
ture range
English
SOLUTION
Make sure that
you tighlty install
the battery pack in
the machine.
Charge the battery
pack.
Replace the defec-
tive parts by an ap-
proved service
center.
Remove the block-
age.
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)
39°F (4°C) - 104°F (40°C)
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
16 LIMITED WARRANTY
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-855-345-3934 .
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of the
purchaser. It is the purchaser's responsibility to pay
transportation charges for any part submitted for replacement
under this warranty unless such return is requested in writing
by Greenworks.
USA address:
Greenworks Tools
P.O. Box 1238
Mooresville, NC 28115
9
EN