Lincoln SKF FlowMaster II Guía De Instalación Y Mantenimiento página 6

Usage
Description
Models ,  and  are pump-
ing units designed to operate a Centro-Matic
lubrication system. Unit includes a vent valve
to relieve line pressure and recharge injec-
tors. FlowMaster II rotary driven electric
pumps include a motor speed control and
built in circuit protection to prevent control
burnout.
FlowMaster II pump is fully automatic
when using a system controller and a pres-
sure switch. Pump is double acting, dispens-
ing lubricant on both up and down strokes.
This unit is designed to be used with SL-V,
SL-, SL-, SL- and SL- series injec-
tors or a combination of these.
Models ,  and  include
a follower plate and mechanical low level
indicator.
Model  includes an electrical high
level switch to indicate when reservoir is full.
Models MSO, MSO and
MSO include an automatic mechanical
shut-off valve for filling reservoir.
Specifications
Supply voltage
Ambient operating temperature
Container capacity
, MSO
, MSO
, MSO
Appropriate use
• Pump on this unit is exclusively designed
to pump and dispense lubricants using
electric power only.
• Do not exceed maximum specification
ratings.
• Any other use not in accordance with
instructions will result in loss of claims for
warranty and liability.
WARNING

Do not exceed   psi (241 bar)
maximum outlet pressure.
Failure to comply may result in
personal injury and damage to system
components.
 V
– to + °F (340 to +66 °C)
 lbs (27 kg)
 lbs (41 kg)
 lbs (57 kg)

Operation with
system controller
When system controller times out, lube cycle
will initiate. Solenoid and pump motor are
energized to close vent valve and start
pump. Pump begins dispensing lubricant
through injectors to bearings.
When all bearings have received lubricant,
pressure rises in system to actuate pressure
switch. When pressure switch actuates, con-
trol is reset to de-energize solenoid valve
and motor. Pump stops, pressure vents and
pressure switch de-actuates. Control begins
timing toward next lube event.
Operation with
mechanical
shut-off
When attached, a mechanical shut-off sys-
tem integrates with bucket pumps to prevent
grease from overfilling during refill process.
System is designed for bucket pumps with
capacity of , ,  and  lbs (27, 41,
54 and 181 kg). Refer to  for mainte-
nance and operating instructions if present.
Table 